about 4 years in the past, I began making some giant finish grain slicing boards however for no matter purpose, I by no means completed them and easily stacked them within the nook of my store. Most of them developed cracks so I figured these would make good inventory for a chaos type board since that entails slicing a superbly good slicing board again up into strips.
So leaping again in time, let’s check out how the prevailing boards started. I used to be left with plenty of scraps after making my very own trim and flooring fro our household room. I additionally had the unique trim from the room which was maple. I planed all these scraps to have a 2″ flat of them and glued them collectively into blanks.
As soon as glued up, I may flatten and clear up the blanks. I ran these by way of the planer to flush every part up after which gave every clean a fast go with the sander to take away something that might trigger the glue seams to be lower than good.
I’ll use the crosscut sled to chop the blanks into finish grain strips. A cease block is used to set the specified remaining thickness of the slicing board.
Every clean is totally different however they’re all the identical width. This enables me to combine and match strips from totally different blanks to realize a seemingly random sample.
The strips get glued collectively, flattened with a router sled, and run by way of the drum sander. For no matter purpose, this was so far as I took this challenge.
Again to the current: I’ll use a monitor noticed to chop an arbitrarily angle onto every board to take away any cracked space.
Utilizing that lower as reference, the board will be lower once more into strips.
These strips are then glued again collectively into a brand new finish grain slicing board.
This course of will be repeated till the sample is loopy sufficient. I made a decision to iterate as soon as extra.
That second iteration made a giant distinction.
Now we will work in the direction of getting the boards completed up. I flattened them with a router sled after which gave them a couple of passes by way of my drum sander to get a head begin on sanding.
The boards are sanded by way of 180.
Subsequent I’ll add the fingerholds. These are lower with a 3/4″ corebox bit within the router. I make mine 4″ lengthy and centered in the long run of the board.
Lastly time for end! I flood on a meals secure varnish and permit the end to soak in. I do know it’s time to flip the board once I can see end beginning to make it throughout the thickness.
As soon as that first coat is cured, I’ll apply a really mild second coat which helps to even issues out. I’m making an attempt to keep away from constructing a movie so knives are slicing by way of end.
[Amazon links are affiliate links]
Jig Noticed: https://amzn.to/2PedA0a
Desk Noticed: https://amzn.to/2XON2Jw
Mud Masks: http://amzn.to/2y8dl1m
Listening to Safety: http://amzn.to/2yQ0sa3
Triton Observe Noticed: http://amzn.to/2f2P85l
Push Blocks: http://amzn.to/2yQD24r
Fingerhold Router Bit: https://amzn.to/2zPale0